diff options
Diffstat (limited to '12.-Appendix.md')
| -rw-r--r-- | 12.-Appendix.md | 4 |
1 files changed, 2 insertions, 2 deletions
diff --git a/12.-Appendix.md b/12.-Appendix.md index 6905f5e..d6fb932 100644 --- a/12.-Appendix.md +++ b/12.-Appendix.md @@ -2,7 +2,7 @@  ## Connecting to an Established WiFi Network -If you are using either the Kraken DF or Kraken PR pre-made images on a fixed WiFi network, instead of using hotspots, then you will need to add your WiFi network details. To do so you will need to temporarily connect your Pi 4 to a monitor and keyboard or connect your Pi 4 using Ethernet and SSH into it. +If you are using either the Kraken DF pre-made image on a fixed WiFi network, instead of using hotspots, then you will need to add your WiFi network details. To do so you will need to temporarily connect your Pi 4 to a monitor and keyboard or connect your Pi 4 using Ethernet and SSH into it. The default login credentials for the terminal and SSH are krakenrf/krakensdr, port 22. @@ -77,7 +77,7 @@ It is up to you the programmer to ensure that the inputs are valid. Entering inc * Docker with ClearLinux ## Working but with major quirks -* Odroid N2/+ - Note: You must use the **BOTTOM USB port that is closest to the DC power barrel jack**. All other USB ports do not work for high data rate devices on this machine. Also requires a high quality USB cable. On this device every ~12 hours there is some USB glitch resulting in sample mis-alignment. This results in the DOA/PR results going bad. If you have periodic recalibration turned ON (the default), it's not a huge deal, but you could be about 5 minutes with bad results. +* Odroid N2/+ - Note: You must use the **BOTTOM USB port that is closest to the DC power barrel jack**. All other USB ports do not work for high data rate devices on this machine. Also requires a high quality USB cable. On this device every ~12 hours there is some USB glitch resulting in sample mis-alignment. This results in the DOA results going bad. If you have periodic recalibration turned ON (the default), it's not a huge deal, but you could be about 5 minutes with bad results. ## Not Working * Tinkerboard - Unfortunately pure 32-bit ARM CPUs are not supported by Miniforge Conda. |